- MOTORCYCLE TYRE
- OTR TYRE
- INNER TUBE
- CAR TYRE
- LIGHT TRUCK TYRE
- TRUCK TYRE
- Tube & Flap
- Light Truck Radial Tyre
- Alloy Wheel
- Radial Off-the-Road Tyre
- Truck Wheel & Rim
- Motocycle tyre
- Truck&Bus Radial tyre
- Passenger Car Radial Tyre
Before assuming that your car has a defective
by：Tanco Tire,Timax Tyre 2020-09-12
The car we're checking out is a 2002 Pontiac Grand Am 4 door sedan. We'll be looking at the driver side (left) front window. The cable mechanism used in this vehicle is typical of many late model GM, Ford and Chrysler vehicles as well as most Asian imports. These systems are light weight, extremely adaptable and inexpensive to manufacture making them the system of choice. Unfortunately, high reliability isn't on the top of this list.
Tap the window switch for the bad window and carefully listen for motor noise, etc. in the door. No noise may mean a faulty switch, motor, regulator or wiring. A motor whirring or grinding sounds may indicate a faulty regulator. In either case, we need to pull the door panel and do a little investigative work to be sure of the fault.
Every rider must have knowledge about tires. They must know its construction, its maintenance and care, how to mount and dismount it, how to troubleshoot and to take precautions. To do it, here are the areas that need to be known:
1. The right size. Sizing is the process of choosing the tire by determining its rim width. This means that the tires must not be wider or narrower than its original equipment tires because to choose otherwise will distort motorcycle handling.
2. Pressure. Pressure increases with temperature. Thus, a rider must check tires regularly especially during winter season. Advisable tire pressures can be found on the manufacturer's reference table. Check them out in order to have a safe tire pressure.
Never bleed air from a hot tire. Also avoid riding when tires are under inflated because this can lead to premature wear, tire failure and damage to the carcass.
3. The Wear. Regularly inspect the wear indicator in the tire grooves. You will know that the tire should be replaced if the wear indicators are leveled with the surface of the tread at any point.
4. The Valve. Always use valve caps to prevent air loss and to avoid dirt from entering the valve.
5. Warm-up. Each time you ride on your motorcycle; always begin at a moderate speed. This will gradually condition the tires up to their normal operating temperature. If they have already achieved a full warm-up then they will have an optimal grip.
6. Break-in. After warming up, avoid rapid acceleration or hard cornering. Do this for the first 50 kilometers of your ride up to the extent when the tread area is totally worn off.
7. Repairs. Try to learn the basics of motorcycle repairs so that you will not be groping in the dark when discrepancies occur. Another option is to consult tire experts to attend to tire repairs.